Furnace Repair · Surrey
Gas Furnace Repair in Surrey, BC
Furnace repair in Surrey is usually a single visit: a diagnostic of about $100 to $200, then a repair that runs $200 to $600 for ignitors, flame sensors and pressure switches. Blower motors and control boards cost more, roughly $800 to $1,500. In BC the work must be done by a gas fitter for a licensed gas contractor.
Get a Quote for Furnace Repair
Prefer to talk or text? Call 778-900-8891 or text a photo.
In Surrey the most common no-heat call comes from a basement-entry house in Newton or Fleetwood where one furnace serves the main floor and the suite. A blocked suite return, a filter nobody changed or closed registers downstairs trip the high-limit switch, and the furnace looks broken when the real problem is airflow. Newer Clayton furnaces fail more often on condensate traps and side-wall vents choked by leaves.
How the diagnosis works
It starts with what the furnace is doing: not starting, trying to light and failing, lighting and shutting off, running constantly, or blowing cold air. The flashing light code on the control board narrows the search, and a meter confirms it before any part is replaced.
Common furnace faults
- Ignitor and flame sensor. Ignitors crack with age; flame sensors coat over and stop proving the flame.
- Pressure switch and venting. A blocked condensate trap, a sagging drain line or a vent holding water trips the switch.
- Inducer and blower motors. Bearings wear and capacitors fail; a rising whine is often the warning.
- Limit switches. A tripping high limit usually means poor airflow: a clogged filter, closed registers or undersized ducts.
- Thermostat and wiring. Dead batteries, a failed smart thermostat or a loose wire.
Who may work on a gas furnace in BC
Gas appliance repairs must be done by a gas fitter employed by a contractor licensed by Technical Safety BC. Ask for the contractor's licence number before work starts. If you smell gas, leave the house and call FortisBC at 1-800-663-9911 or 911 first.
Frequently asked questions
Why is my furnace blowing cold air in my Surrey house?
Cold air usually means the burners are not staying lit while the blower keeps running. On high-efficiency furnaces the usual causes are a dirty flame sensor, a failed ignitor or a pressure switch tripped by a blocked drain or vent. Check that the thermostat is set to heat and the filter is clean, then book a diagnosis.
How much is a furnace ignitor replacement in Surrey?
Lower Mainland contractors commonly charge about $350 to $600 for an ignitor or flame sensor replacement with parts and labour, in 2025-2026 terms. Simple flame sensor cleanings cost less. The exact price depends on the furnace make and whether the part is on the truck.
Can a suite tenant cause the upstairs furnace to fail?
Indirectly, yes. Closing every register in the suite, blocking the only return with furniture or never changing a filter starves the furnace of air, and the high-limit switch shuts it down. It is a design problem in many Surrey suite houses; duct balancing or a separate ductless head fixes it.
Should I reset my furnace again if it keeps shutting off?
One reset at the furnace switch is reasonable. Repeated resets that buy a few minutes of heat usually mean a sensor, drain or venting fault, and some furnaces lock out after several failed tries. Note the flashing light code on the control board before you call; it speeds up the diagnosis.
Who is allowed to repair a gas furnace in Surrey?
In BC, a gas furnace must be repaired by a gas fitter employed by a gas contractor licensed by Technical Safety BC. Homeowners can change filters and thermostat batteries, but not gas components. Ask for the contractor's licence number; it can be checked with Technical Safety BC.
Request a Quote
Prefer to talk or text? Call 778-900-8891 or text a photo.
Serving Surrey and surrounding areas. Contact us for a no-obligation quote specific to your property.